When I follow https://docs.petoi.com/chapter6 using WriteInstinct.ino, MPU calibration seems to work as described, but when afterwards I press 'c', nothing happens, servos don't move and the long calibration table (Index/Offset) doesn't print. By inserting a print statement, I verified that execution reaches line 259 of WriteInstinct.ino. I just pulled latest from git repo so it's the latest code.
Tried testing the servos by running testServo.ino - if I just run it, servo on pin 1 goes back and forth; but if I enter 'a', all servos move once and then stop moving. The output on the serial monitor, if I do that, goes from reasonable numbers (less than 1000 in absolute value) to very large numbers (attached) - not sure if that is connected to the calibration issue.
Any idea what could be going on there?
Thanks a lot!