WriteInstinct locks up after MPU calibration. No response after to "c" command.
Have latest Arduino IDE, NyBoard support, updated libraries, edited Instinct.h to NyBoard_V0-2
Serial Monitor 57,600 baud, No Line Ending
All servos connected, battery switched on
Install WriteInstinct and open serial monitor,
Reset Joint calibration (Y)
Update Instincts (n) I get single lines 1-42 and Finished!
Calibrate MPU (Y) Finished! Offsets saved automatically
type "c" beep and no further response in serial monitor
If I close and reopen serial monitor entire process starts over again with same results.
Any suggestions and thanks.