Zee JSep 3, 2020Thank you! Could you please share a video or pic of the cross shaped arm you mentioned above. Appreciate the help.
FuzzyFoyzSep 3, 2020@Zee J I thought the same thing when I started building my Nybble! But no, all the parts are there and you have plenty of screws! :)
FuzzyFoyzSep 3, 2020Oh and be very very careful with the foot pads, they can snap if over stretched (I snapped one :(...) Watch the videos!
Rongzhong LiSep 3, 2020The foot pads are optional. Sometimes Nybble walks better without them. You may try to use some hot glue to increase friction if all pads are broken.
Rongzhong LiSep 3, 2020This is the cross shaped arm. You need to cut two branches off to make the L-shaped part.
Zee JSep 6, 2020The plastic is too hard to cut.. Any ideas how to make that happen? I used a knife but it is not easy
It's cut from the cross shaped servo arm.
Thank you! Could you please share a video or pic of the cross shaped arm you mentioned above. Appreciate the help.
@Zee J I thought the same thing when I started building my Nybble! But no, all the parts are there and you have plenty of screws! :)
Oh and be very very careful with the foot pads, they can snap if over stretched (I snapped one :(...) Watch the videos!
The foot pads are optional. Sometimes Nybble walks better without them. You may try to use some hot glue to increase friction if all pads are broken.
This is the cross shaped arm. You need to cut two branches off to make the L-shaped part.
Thank you!
The plastic is too hard to cut.. Any ideas how to make that happen? I used a knife but it is not easy
I just used a pair of scissors, a sharp pair would do it.
You could heat up the knife then it would be like cutting cheese.