I have a problem with my Bittle. Everything through assembly and calibration went perfectly however after installing OpenCat.ino the only response it seems to give is a weird twitch where it lifts one leg and then pulses. It won't walk or leave this position. When lifting, it moves legs as if to balance.
I have tried communicating through bluetooth, the Serial Monitor, and with the IR remote. All are the same. Using the IR remote test sketch the buttons seem to come through fine. Any ideas?
After uploading writeInstinct.ino, have you set up the serial monitor correctly and entered “yyy” to save the constants? Have you set the unused encoders in IRremote.h to 0?
I had not set the unused encoders to 0 so I went back and did that, then re-ran the writeInstinct process again to be safe. Not sure which one did it but it is working perfectly now, thank you!
@Austin happy to hear that!