I've fixed the previous issue where I was not correctly using the serial console, but I'm still having issues with servo calibration.
I ran the testServo app - Only servo 0 did anything - even though the serial output showed a long range of numbers, the stepper only ticks for 13 steps when the range of numbers crosses zero - when the first digit is 139.66 through -139.66 (inclusive).
When run calibration from WriteInstinct, all of the servos move a few ticks then stop.
I've measured 7.8v coming in from the batteries - Have the NyBoard set to V_S<->BATT.
Should the testServo app work out-of-the-box with the v2 NyBoard and Kickstarter default servos?