I am very confused about a lot of things and im hoping there are some answers. the first question I have is soldering mandatory? can you finish without soldering? if not what do I need to solder and where. also where do I plug in the ultra sonic sensor? how do I plug in the battery pack to the nyboard? how do I connect the controller? and also a basic understanding of where to start with uploading the code in an easy way. I know im asking for a lot but honestly I know nothing about coding and I REALLY didn't know what I was getting into when I bought this. nevertheless I am VERY excited for the end product and I hope I can figure it out. if anyone is willing to answer this rather long list of questions thank you so much and I hope I can finish this. thanks. (FYI I have the Nyboard VO,2. I have not attached my raspberry pi. also I have downloaded everything from GitHub and I connected my nibble to my computer. I also downloaded Arduino sketch. I just need to know what to do from there.)
I really need help with this please!
I'm attaching some pictures here for your convenience. Most of your questions can be answered by reading the instruction doc.
1) the first question I have is soldering mandatory? can you finish without soldering?
Soldering is not mandatory to make the cat walk.
2) if not what do I need to solder and where. also where do I plug in the ultra sonic sensor?
Ultrasound wiring is not mandatory.
3) how do I plug in the battery pack to the nyboard? how do I connect the controller? and also a basic understanding of where to start with uploading the code in an easy way.