Does anyone have the Bittle 3D model for the MU vision sensor holder?

Question

As seen in red in the picture below. I'd love to 3D print it :D

Brad S · Accepted Answer

I'm finding with Bittle's overbite the camera faces down a little too much (the top of the mouth is further out than the bottom). has anyone printed a modified bone that pushes the camera out at the bottom to tilt it up a little? or any other ideas?

Rongzhong Li · Answer

You can download the structure at https://github.com/PetoiCamp/NonCodeFiles/blob/master/stl/bone.stl

Robotics for Everyone

It worked fine until yesterday, but...

Driving bittle from Raspberry PI

Anyone get PetoiControllerMac working?