copy opencat No.1

Just wanted to share my 3D printable version of the original Nybble as seen in Volume 70 of Make Magazine. This is such a great little design and my daughter is loving her new pet kitten! https://www.thingiverse.com/thing:4015171

Dear Sir, I followed your development steps and wanted congrats for your works and sharing’s. When you published the repository about CatMini I decided to test and made my own 3D printed frame and electronics because the biomimetics of cat appeared to me a good model too. Here is a short video of my version “Spring”, hope you will enjoy. My hobby is also link to robotic applications and I did some robots of my own mainly focusing on alternative way of moving / interacting https://www.facebook.com/versatilerobot and try to share this passion to young's by involve into a robotic French association "Caliban" https://www.facebook.com/AssoCaliban/ I look forward seeing your next developments Best regards, VR

Hey Comrades, So I figured out how to use GoPro with OpenCV. Now my plan is to put the GoPro on the Cat and make it do stuff. However, I can't figure out how to put it properly. In the video below I have just tied it up with a string to observe how the new weight distribution affects the physical behavior of the cat with the current motion planning algorithms. The cat always falls over while walking and trotting, but works reasonably well with crawling-the lower center of gravity while crawling probably makes it more stable. Is there any genius friend out there who could help me design a GoPro mount for a Nybble? Regards, Zaigham Abbas