top of page

Forum Comments

I am setting up Nybble for the first time with only the Nyboard. When I get to the calibration step, nothing happens after typing 'c'.
In Basic Assembly and Setup
Howard Patterson
Aug 28, 2020
@Rongzhong Li I changed out the SW3 jumper. It appeared loose, and when I replaced it, calibration proceeded as it should. Thanks for the help! I am excited about Bittle and look forward to his progress. Keep up the good work!
I am setting up Nybble for the first time with only the Nyboard. When I get to the calibration step, nothing happens after typing 'c'.
In Basic Assembly and Setup
Howard Patterson
Aug 27, 2020
Battery is powering board, and I double-checked the orientation of the plugs for the servos.
Is it possible to add a Raspberry Pi later after building Nybble with only the Nyboard? Or should I go ahead and install it during the build
In Basic Assembly and Setup
Howard Patterson
Aug 12, 2020
Nice work! What functions of the pi are you using?
My DIY 3D Printable version of Nybble on Thingiverse
In Showcase
Howard Patterson
Dec 05, 2019
Thanks for sharing this! Very cool version.
1
0
Spring by VersatileRobot
In Showcase
Howard Patterson
Dec 03, 2019
I also admire the springs and I love the clickity-clack of the feet.
0
0

Howard Patterson

More actions
bottom of page